2023+ Nissan 400Z AMS Alpha 5 Performance Package (500HP)

2023+ Nissan 400Z AMS Alpha 5 Performance Package (500HP) - AMS.47.10.0001-1

When AMS first drove the new Nissan Z, they knew there was massive potential for improvement. The AMS team immediately set to work developing the most comprehensive performance package on the market, made to spec with E85 ethanol fuel in mind. With the ALPHA 5 Performance Package for the Nissan Z, they have developed the perfect combination of intake, exhaust, cooling, and fuel system modifications, allowing your Z to achieve an incredible 500 horsepower output. The ALPHA 5 Performance Package is a true Flex Fuel compatible system, and the parts list has been custom tailored specifically for use with E85 ethanol fuel, readily available from many gas stations across the country. This fuel selection allows for higher performance due to its higher octane rating and cooling properties compared to your standard 93 octane pump gasoline. All of the parts within the ALPHA 5 package have been selected to deliver the highest performing and most reliable vehicle possible. Simply install the ALPHA 5 components and have your Z tuned to unlock your Z’s inner 500 horsepower tire slayer!

*500 HORSEPOWER CAPABLE WHEN USING E85*
*FULLY FLEX FUEL ENABLED – E30, E50, E85, E98 ETHANOL COMPATIBLE
*APPX. 130 WHP INCREASE OVER STOCK*
*10 SECOND QUARTER MILE TIMES ACHIEVABLE*
*CREATED AS A “FULL BOLT ON” (FBO) PARTS PACKAGE
*FULL FUEL SYSTEM UPGRADE TO SUPPORT 500 HP ON ETHANOL*
*ENHANCED COOLING EFFICIENCY TO HANDLE THE POWER
*FREE FLOWING INTAKE AND EXHAUST TO LET YOUR ENGINE BREATH

2023+ Nissan 400Z AMS Alpha 5 Performance Package Includes:
- AMS Performance Nissan Z Cold Air Intakes
- AMS Performance Nissan Z Heat Exchanger
- AMS Performance VR30DDTT Race Lower Downpipes
- AMS Performance VR30DDTT Stage 1 High Pressure Fuel Pump
- AMS Performance VR30DDTT Low Pressure Fuel Pump
- AMS Performance Nissan Z Flex Fuel Kit
- AMS Performance VR30DDTT High Pressure Fuel Sensor
- AMS Performance ALPHA 5 Decal Set 

PRODUCT NOTES
*Performance may vary by vehicle. With the ALPHA 5 package installed with our in-house AMS ECU Calibration we generally see, at minimum, 490 WHP and 490 lb-ft of torque when measured on our Dynojet 424xLC2 Dynamometer. Power output may vary depending on many factors including, but not limited to, altitude, temperature, fuel octane, engine tolerances, tune, and dyno used. Performance numbers aren’t guaranteed but are common results seen by our customers. Quarter mile times, 0-60 mph, 60-130 mph and other recorded times are approximate and can vary significantly depending on numerous factors such as ambient temperature, elevation, tire selection, road surface material, fuel octane and quality, transmission selection, and vehicle weight, among many others. The advertised numbers herein are based on optimal conditions and utilizing proper supporting modifications, but are generally attainable results by an average customer. Your results may vary.
**Installation and ECU calibration labor are not included. Necessary ECU calibration software and hardware, such as EcuTek RaceROM and ECU Connect OBD2 Interface, are not included. For a complete estimate on having AMS Performance install and tune this package, please contact our sales department.
***ECU Calibration is REQUIRED for the safe operation of the engine once ALPHA 5 Performance Package parts are installed.

RACE / COMPETITION / INTERNATIONAL USE ONLY
This product is designed for installation on a race-only vehicle, defined as a vehicle that is used exclusively for competition and that cannot be licensed or registered for use on the public roads and highways within the United States. This product is not available for sale on emissions-controlled vehicles within the United States without a completed AMS Race Waiver form. International users outside of the United States should act in accordance with their local laws and regulations.